In this study, we propose a novel and simple fabrication method of the microfluidic device, with high-aspect-ratio (HAR) microchannel for microparticle separation under viscoelastic fluid flow. To fabricate the HAR (> 10) microfluidic device comprised of the Si channel and PDMS mold, basic MEMS processes such as photolithography, reactive ion etching and anisotropic wet etching of Si wafer were used, and then plasma bonding with mechanical alignment between the Si channel and PDMS mold was conducted. The width of the microchannels was determined by the difference between the Si channel width and the master width for the PDMS mold. On the other hand, the heights of the Si channel and PDMS mold could be controlled by the KOH etching time and spin-coating speed of SU-8, respectively. The HAR microfluidic device whose microchannel had 10 μm width and 100 μm height was successfully fabricated, and used to separate microparticles without other external forces. The effect on the particle focusing position and focusing width under viscoelastic fluid was investigated, depending on the flow rate and the microparticle size. It is expected that precise manipulation as well as high-throughput separation of microparticles, can be achieved using the microfluidic device with HAR microchannel.

In this paper, we propose acoustophoretic microfluidic devices with an acoustic transparent polymer wall using a simple and low-cost fabrication method followed by MEMS (Micro-Electromechanical Systems) processes. Generally, due to the acoustic standing wave between two opposing walls in microfluidic channel, the particle focusing lines are fixed according to the applied frequency. In the proposed device, however, it is possible to place the particle focusing lines in the arbitrary position within the fluidic domain through the optimized width of polymer wall. The PDMS (Polydimethylsiloxane) mold with thin layer was used as the sealing layer between the Si substrate and cover glass, as well as the decoupling layer between the acoustic boundary and fluidic boundary. The thickness of PDMS mold needed to be minimized to decrease the heating by the acoustic energy absorption of PDMS layer, which was successfully made using the spin-coating of PDMS and the UV tape transfer method. The acoustophoretic device with thin PDMS layer and optimized width of PDMS wall can be applied, for biotechnological applications such as the separation of blood cells and micro-particles.