This study introduces a novel adjustable fastening mechanism for wearable robots, aimed at alleviating user discomfort associated with traditional fixed attachment methods. By utilizing the unique scissoring effect of braided sleeves, we demonstrated that axial manipulation can effectively translate into radial size control, allowing for precise regulation of fastening force. To address the size limitations of commercial braided sleeves, we developed a large-area fastening structure by combining multiple braided sleeve sheets. Additionally, we incorporated a wire tendon system to enable active operation in both Daily Mode (fastening-release) and Exercise Mode (fastening-tightening). Experimental results on an anthropomorphic model revealed that this adjustable fastening structure offers variable fastening forces, achieving a 4.8-fold difference between the exercise and daily modes. This research presents a new approach by leveraging the Poisson's ratio properties of braided sleeves for dynamic fastening, tackling fabrication challenges for large-area structures, and improving user comfort and compliance in wearable robot applications

Mobile harbor which is a novel concept of ocean transportation to bring the containers from the cargo ship waiting on the ocean away is being focused now. To provide the mobile harbor with the stable loading/unloading condition, it is necessary to develop the oscillation mitigation technologies such as anti-rolling system. Anti-rolling system using AMD(Active Mass Driving) has merits that it can handle the disturbances more actively and mitigate the rolling oscillation faster than other type anti-rolling system. However, rack-and-pinion type AMD has problems such as big friction noise from gears and motor, wear and tear, and continuous maintenance. In this paper, novel anti-rolling system using Maglev type AMD for mobile harbor is suggested in order to resolve the problems caused by the friction. This novel anti-rolling system doesn’t make any friction because it supports the moving mass by using magnetic levitation force and moves it by using propulsion force from the linear motor. The demo system of the novel anti-rolling system using maglev type AMD has been developed in order to investigate its feasibility. This paper presents the procedures and results of development of this demo system.

Recently PMSM(Permanent magnet synchronous motor) are used for the various direct drive applications such as index table, telescope system and so on. Because the position/speed control performance of direct drive PMSM is directly affected by the torque ripple, there are lots of studies to reduce the cogging torque in the motor design stage. In order to verify the motor design, the reliable cogging torque measurement system is essentially required. The measured motor must be rotated in the constant speed under 1deg/sec so that the cogging torque profile is measured correctly. In this study, the cogging torque measurement system which uses the direct drive PMSM and the speed controller to rotate the measured motor in 0.1rpm(0.6deg/sec) has been developed. Simulink/xPC target was used for the controller and data acquisition system. Based on PI controller, DOB and AFC have been applied to eliminate the low frequency disturbances and the periodic speed ripple. The experimental results show the good performance of the speed regulation for the reference speed 0.1rpm and the reliable profile of the measured cogging torque by the developed speed controller.

5kWh FESS(Flywheel Energy Storage System) using AMB(Active Magnetic Bearing) has been under development and 1 st trial system has been finished and run the operating test. Unfortunately, the test result was not satisfactory because FESS could increase the rotational speed up to 9,000 rpm only although the target rotational speed is 18,000rpm. It's because 1st bending mode frequency of flywheel shaft was too low and imbalance response was too big. To achieve the target speed, 1st bending mode and imbalance response must be improved and the whole FESS needed to be designed again. This paper presents the newly designed FESS and what has been changed from the 1st trial FESS to improve 1st bending mode and imbalance response. The experimental results to see how much 1 st bending mode frequency was improved are presented, too.